HSF5100 Grain Filler

Target Coatings HSF5100 High Solids Filler

Target Coatings HSF5100 is a high solids, thermoset urethane grain filler formulated for application by trowel, brush or spray.

Specifically engineered to provide a smooth, non-textured appearance on open grained woods like Oak, Ash, Walnut, Mahogany, etc.

Supplied as a neutral colored (tan-putty color) filler that can be used directly on light colored woods. Filler can be tinted to suit darker woods as required and to prevent a "grey" color in the open grain. Apply filler directly over bare wood if desired or over pre-stained, sealed surfaces.

Brush and wipe filler into grain/pores and allow to set for 5 to 10 minutes. Squeegee off excess and allow to dry for 2 hours. Level sand with 400 grit paper and re-apply filler if required or proceed to remainder of finishing schedule.

The fast drying nature of this system allows topcoats to be applied in as little as 2 hours of initial dry-to-touch time with any water-based topcoat finishing system.

• Low VOC
• Water Clean-Up
• Non-Flammable
• Supplied as Neutral (tan-putty, NOT transparent) color
• Tintable with ColorFX Dyes, Mixol Pigments or UTCs to create matching or contrasting grain patterns
• Spray, Brush or Wipe on